Transport Rates
OBJECTIVE
The Transport Rates option is used to establish an hourly rate or a rate per kilometre based on the number of axles and the region.
|
|
Various tables are usually created based on the type of material carried. |
PREREQUISITE
Steps
| maestro* > Tickets > Maintenance > Quarry Tickets > Transport Rates |
Creating Transport Rates
- Enter the required information:
Field
Description
Table Number
Table number or name.
Material
Material for which the table applies.
- Enter the required information in the Hourly Rates tab:
- Rates for trucks or set of vehicles section:
Field
Description
Zone
Zone for which the rates apply.
NOTE: The zone is from Zone Management.
2, 3, 4, 5, 6, 7 and 8 Axles
Used to enter the hourly rate invoiced based on the number of axles in the vehicle.
NOTE: This rate is multiplied by the number of hours driven by the trucker.
- Enter the required information in the Ton-Kilometer Rates tab:
- Rates per kilometer or fraction of additional kilometer section:
Field
Description
Zone
Zone for which the rates apply.
NOTE: The zone is from Zone Management.
Number of Axles
Allows to indicate a truck's number of axles.
NOTES: The available numbers are 0, 2, 3, 4, 5, 6, 7, 8 and 9. The number 0 corresponds to a "non-specified" value, since it is not necessary to indicate a truck's number of axles in the Truck Management option.
The number 1 is not available since it is physically impossible for a truck to have a single axle.
From x to y Km
Rate applicable per kilometer.
NOTE: The rate is added from one column to the next. For example, Col1+col2+col3. Therefore, the content must include the difference added to the rate in column 1.
NOTE: The system displays the ranges created in KM Range Management.
- Click Save.